In addition, when selecting a reasonable thickness of steel plate, the manufacturer of stainless steel plate shall consider its service time, quality and stiffness, as well as the strength requirements when the plate is pressed, heat conductivity, pressure distribution and the width specification of the pressing plate.

If the steel plate is not thick enough and easy to bend, it will affect the production of decorative plate. If the thickness is too large and the steel plate is too heavy, it will not only increase the cost of steel plate, but also make it unnecessary to play with the price of stainless steel plate in operation.

At the same time, consider the allowance that should be left when processing or using the stainless steel plate. The thickness of the copper plate is not consistent, but strive to be consistent in the thickness of the same steel plate as much as possible. Generally, the thickness tolerance of the medium-sized saw plate is 0.05-0.15 mm. If the requirements are too strict, the grinding cost will also increase with it. 304 stainless steel plate is generally a structural steel plate with high tension resistance and hardness. The greater the mechanical damage resistance, the longer the durability, But the cost of grinding is also relatively high.

Stainless steel is strong and easy to deform. In the process of machining and cutting, stainless steel, especially austenitic stainless steel, will have greater plastic deformation because of its inevitable elongation, which makes it difficult to cut 201 stainless steel plate. Moreover, the strength of stainless steel is large, which increases the two-way resistance in the process of cutting and strengthens the cutting strength.

The cutting temperature of stainless steel is high, and a large amount of heat will occur during the cutting process. However, the stainless steel material has a poor thermal conductivity ratio, so the heat is concentrated on the 316L stainless steel plate and blade in the cutting area, which is not easy to dissipate heat and is difficult to cut. Stainless steel is a hard material with good plasticity and toughness. However, during processing, the cutting is not easy to break and easy to adhere, resulting in cutting and extrusion of stainless steel, Causes excessive tool wear. (this is because the tool is worn, resulting in potholes on the tool surface, forming small spalling and notches)